Scooter GY6 50cc engine studs

Scooter GY6 50 cm³ engine studs: the photo shows four silver-coloured studs, two shorter and two longer, and the diagram marks "M 7" at their thread. Measure your old studs before ordering.

• The engine studs hold the cylinder and its head: the lower ends are screwed into the crankcase, and nuts are screwed onto the upper ends.
• We measured where the lines end: the "M 7" arrows end on the upper threads of the two middle studs, "D 5,8" – on their smooth sections.
• The lines for the outer studs are drawn end to end, and 670 mm and 750 mm are written next to them. That would be 67 and 75 cm – unusually long for an engine stud, so we do not rely on these numbers.
• The name gives no thread, no length and no quantity – we know M7 and D 5,8 only from the diagram.
• The photo has no nuts and no washers.

We write only what we know. The diagram's lengths raise doubts, and the name gives no length, so we do not guess it; GY6 50 cm³ is given without the scooter model, so we do not promise fitment either. Before ordering, measure your old studs' length end to end and their thread, send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56