Carburettor jet M6 0,80

Carburettor jet M6, 0,80 mm hole. A jet (nozzle) is a small screw with a calibrated hole: it meters the petrol going into the air stream. A larger hole lets through more petrol – the mixture runs richer; a smaller one lets through less – the mixture runs leaner.

• Thread M6 and hole 0,80 mm – both must match what you unscrew from your own carburettor
• Supplier code WI AI302044 – quote it if you order again
• You'll swap it in a few minutes: unscrew the carburettor's bottom, take out the old one, screw in the new one
• After changing the exhaust, air filter or cylinder, the mixture usually goes leaner, and you need a larger main jet – the size is found by trying it, not by calculating it
• Neighbouring M6 thread sizes are 0,75 and 0,83 mm; look for these jets and jet kits in the "Carburettors and their parts" category

To be straight with you: the jet is only marked with the thread and the hole. Which carburettor it fits, and whether it will be the main jet or the idle jet in yours, the manufacturer does not say. Jets of the same thread differ in length and head between different carburettors, so a matching thread alone is not enough: compare it with your old one, or send us a photo of it – we'll tell you if it matches.

24-month warranty · tel. +370 685 777 56