Carburettor jet M5 0,95

Carburettor jet M5, hole 0,95 mm. The jet doses the petrol that enters the air stream. The hole size sets the richness of the mixture: bigger – more petrol, smaller – less.

• Thread M5 and hole 0,95 mm – both must match what you unscrew from your carburettor
• Supplier code WI AI302035 – quote it if you order again
• Takes a few minutes to change: unscrew the bottom of the carburettor, unscrew the old one, screw in the new one
• After changing the exhaust, air filter or cylinder, the mixture usually goes lean, so the main jet has to be taken bigger – the size is picked by testing, not by calculation
• Neighbouring M5 thread sizes – 0,90 mm and 1,00 mm; look for such jets and jet kits in the category "Carburettors and their parts"

To be straight with you: the jet shows only the thread and the hole. Which carburettor it is for, and whether it will sit in yours as the main jet or the idle jet, the maker does not say. Jets of the same thread differ in length and head between carburettors, so a matching thread alone is not enough: compare with your old one or send us a photo of it – we will tell you if it matches.

24-month warranty · tel. +370 685 777 56