Skip to content
CUSTOMER SUPPORT: +370 685 777 56
Tyre valve, straight - Image 1
Inner tubes & valves

Tyre valve, straight

Article no. 60905
2 €
Prices incl. VAT
In stock — Šakiai

Order by 16:00 — Omniva ships today

1
Not sure it fits your bike? Ask our mechanics or see our fitment-by-VIN FAQ
Same-day dispatch — order by 16:00
24-month guarantee
14-day returns
In stock in Šakiai

Product information

Snap-in valve, straight – rubber base with a straight brass stem and cap.

  • A snap-in (push-in) valve is fitted into the rim hole from the inside and is held by the rubber itself – it needs no nut
  • A straight stem suits a rim where the hole is in a flat part and faces straight outward – this is the most common case
  • Replace it when the rubber cracks at the edge of the base or the valve leans over from centrifugal force: both cases end in a slow air leak with no visible hole
  • Before ordering, measure your rim hole: the most common sizes are 11,3 mm and 8,3 mm, and the valve must match exactly that
  • The photo shows a thicker rubber base than the angled valve, a straight brass stem and a black cap
  • Supplier code AT 50F1710-4WP – quote it if you order again

To be straight with you: neither the name nor the photo gives the rim hole dimension – measure your own before ordering. Which specific motorcycle or ATV it fits depends not on the make, but on the tyre size. Take out the old tube or look at the side of the tyre and send us the marking – we will check it before you order.

24-month warranty · tel. +370 685 777 56

VIEW ALL