Tyre valve, curved

Snap-in valve, bent – rubber base with a brass bent stem and a cap.

• A snap-in (push-in) valve is fitted into the rim hole from inside and is held by the rubber itself – it needs no nut
• The bent stem is needed where the rim hole is on the side, or where there is too little room by the hub for the pump nozzle
• Replace it when the rubber cracks at the edge of the base, or when the valve leans over from centrifugal force: both end in slow air loss with no visible hole
• Before ordering, measure the rim hole: the most common are 11,3 mm and 8,3 mm, and the valve has to match exactly that one
• The photo shows all three parts: the rubber base, the brass bent stem and the black plastic cap
• Supplier code MO 5916312018884 WI ZLO52051 – quote it again when ordering

To be straight with you: the rim hole size is in neither the name nor the photo – measure your own before ordering. Which exact motorcycle or ATV it fits depends not on the brand but on the tyre size. Take out the old tube, or look at the side of the tyre, and send us the marking – we will check it before you order.

24-month warranty · tel. +370 685 777 56