Voltage regulator relay 7 wires (3 yellow 1 black 1 red 1 white 1 green)

Voltage regulator relay with 7 wires – 3 yellow, 1 black, 1 red, 1 white and 1 green: the photo marks 65 mm between the mounting-hole centres. Measure the distance between your old regulator's hole centres before ordering.

• The regulator keeps the generator's voltage at a level the battery and bulbs can still tolerate; when it fails it either stops charging or starts blowing bulbs
• We measured the arrow ends: both ends of the 65 mm line land exactly on the mounting-hole centres, so it is the gap between hole centres, not the housing width
• We checked the wire list against the photo: the three yellow, the green and the red are clearly countable, while the black and the white are visible only in part – right at the connector blocks
• The wires lead into two white connector blocks and are bound with black wrapping
• The housing is cast, grey and ribbed; the mounting holes are on opposite edges, without bushings
• The three yellow wires are usually the generator phases, but nothing on this part says so, so we do not claim it
• The photo gives no voltage, no current and no hole diameter
• Supplier code WI AW0068 KCH2222 – state it again when ordering

To be straight with you: which wire connects to what, the maker did not write, and we do not guess: connect it by guesswork and you burn out the regulator or the generator windings. Which model and which years it fits is also not stated. Before ordering, measure the distance between your old regulator's hole centres and count the wires, send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56