Silencer exhaust gasket with mesh

Silencer exhaust gasket with mesh – dark grey, elongated, with rounded ends and two mounting holes: 60 mm long and 37 mm wide in the drawing, Ø 22 mm centre bore. Compare it with your old gasket before ordering.

• The gasket sits between two exhaust-system flanges and seals the joint; which joint that is, the name does not say.
• We measured the ends of the lines: 60 mm – full length between the lug ends, 52 mm – from the outer edge of the left hole to the outer edge of the right hole, 37 mm – width across the middle.
• The Ø 22 mm arrows rest on the edges of the centre bore, and the right-hand hole is marked Ø 6 mm.
• The name says "with mesh", but the photo shows only a dark grey surface with light specks; we cannot make out the mesh pattern.
• The photo gives no gasket thickness.

We write only what we know. Which engine the gasket is for and where the mesh sits in it, the name does not explain – we do not guess. Before ordering, measure your old gasket's length, the distance between the outer edges of the holes and the bore diameter, send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56